DEM exported as XYZ grid, points shifted upwards by approx. .4 meters
My typical workflow for going from a DEM created in Agisoft to autocad is to take the DEM, put it into GM, and create a 3 to 5 meter XYZ grid of points. However, on a recent project, all the points are being created about .4m above the DEM surface. I can see this in autocad and in GM. I found this by importing the point grid I had just exported in GM back into the GM model, hovering over a point, and looking in the bottom of the screen where it shows the point elevation along with the surface elevation. This issue is consistent across many points I tested. What in the world is causing this? I've done this exact workflow many many times with no issues.