Ridgetop Peak Contour

When modeling wind speeds it is very important to have each ridgetop's peak elevation as accurate as possible. Would it be possible in future versions to have an option to calculate the highest point of each ridge and draw a new contour that is smaller than the specified contour interval. For example, I need 20 ft contours across an area of 20 km wide. For each mountain top the actual elevation may be 2019 ft but GM will stop at 2000 because the contour interval I specified is 20 ft. Is it possible for it to recognize the highest point and either draw a new contour of 19ft or draw a point with this height?? Having to go in manually after creating each contour file has been a painstaking task.
Also, 10m NEDs would be a great addition!
Thanks, James
Also, 10m NEDs would be a great addition!
Thanks, James
Comments
Thanks,
Mike
Global Mapper Support
support@globalmapper.com
Thanks,
Mike
Global Mapper Guru
gmsupport@bluemarblegeo.com
http://www.globalmapper.com
Thanks