Export in decimal degree

Celine18
Celine18 Global Mapper User
edited September 2011 in Projection Questions
Hi everybody,

I would like to export an elevation file in decimal degrees. How can I do this?
Thanks

Comments

  • global_mapper
    global_mapper Administrator
    edited September 2011
    Just set your projection to Geographic/Arc Degrees on the Projection tab of the Configuration prior to export and you should get decimal degrees for the units when you export.

    Let me know if I can be of further assistance.

    Thanks,

    Mike
    Global Mapper Support
    support@globalmapper.com
  • Resourceful
    Resourceful
    This is a good question - following the instructions above still gives degrees / minutes / decimal seconds with the batch reproject function.  The Convert tool also displays the same thing, unless you close and re-open it - then it gives decimal degrees as well.

    If there is a way to get to decimal degrees in the Reproject tool, that would be great!
  • bmg_bob
    bmg_bob Global Mapper Programmer
    Hello,

    Please provide more details about your workflow with the batch reproject function. What format are you converting from? What format are you converting to? What setting do you have for Position Display Format on the General | Measure/Units tab of the Configuration dialog?

    Cheers,
    Bob
  • WindFlow
    WindFlow
    https://www.globalmapperforum.com/discussion/comment/23211#Comment_23211

    Thanks for the response, Sir. It's a great help.

  • WindFlow
    WindFlow

    I will contact again if i face any issue in future.

    Regards, Wind_Flow

Categories

In this Discussion