Setup Sample Spacing - Sample Features at Fixed Distance Interval, off by 1

Jake
Jake Global Mapper UserTrusted User
edited August 2012 in Bug Report
I noticed that when creating points along a 100 nautical line via the "Setup Sample Spacing" dialog box, using the "Sample Features at Fixed Distance Interval" option, the counting starts at 1 not 0. Thus at 10 nautical miles the label for the point is 11 and so on.

This could be due to the fact that for another line I selected "Sample Features at Fixed Number of Regularly Spaced Locations" and the Start Label Number was 1.

See attached graphic for output.

Comments

  • global_mapper
    global_mapper Administrator
    edited August 2012
    Yes you can change the Start Label Number value to start at whatever you need. For your screenshot you have it at 1, so that's where the values start. Just change that to 0. It is a bit confusing as the option is up under the other option, it just wasn't duplicated under the other option but instead just highlights when either are active.

    Thanks,

    Mike
    Global Mapper Guru
    gmsupport@bluemarblegeo.com
    http://www.globalmapper.com
  • Jake
    Jake Global Mapper User Trusted User
    edited August 2012
    Ah I see. So it should be treated as a check box instead of a radio button. Thanks for the clarification.

Categories

In this Discussion