Global Mapper v25.0

Contours not visible

s2banham
s2banham Global Mapper User
edited January 2012 in Technical Support
I have Gm 12.02 32 bit on one computer and GM12.02 64 bit on a laptop. I can generate contours and see them in the 32 bit version but when I try using the same data on my laptop, the contours are'nt visible. According to the metadata they have been created, but they can't be seen. Any help is appreciated.

Stu

metadata:
FILENAME=
DESCRIPTION=GENERATED CONTOURS
AREA COUNT=0
LINE COUNT=293760
LINE VERTEX COUNT=627175
POINT COUNT=0
UPPER LEFT X=655065.605
UPPER LEFT Y=5765856.012
LOWER RIGHT X=656876.365
LOWER RIGHT Y=5762406.180
WEST LONGITUDE=114° 44' 29.6252" W
NORTH LATITUDE=52° 01' 17.8958" N
EAST LONGITUDE=114° 42' 49.0786" W
SOUTH LATITUDE=51° 59' 24.4901" N
PROJ_DESC=UTM Zone 11 / NAD83 / meters
PROJ_DATUM=NAD83
PROJ_UNITS=meters
EPSG_CODE=26911
COVERED AREA=2.412 sq mi

Comments

  • global_mapper
    global_mapper Administrator
    edited January 2012
    Check the Vector Display tab of the Configuration dialog and make sure that you have line display enabled and that you haven't disabled contour lines in the line filter. I'm guessing one of those is disabled.

    Thanks,

    Mike
    Global Mapper Guru
    gmsupport@bluemarblegeo.com
    http://www.globalmapper.com
  • s2banham
    s2banham Global Mapper User
    edited January 2012
    Thanks Mike - Guess I mistook the check marked filter selection as meaning it was turned off.